Project 2

 

Project #2  motor  control  with  counts

 

In Project 2, I  have learned how to use a  motor control sensor to connect the Stepper Motor board. In this project, I   could not use regular jumper cable for this project so I used Male to  Female Jumper cable to connect Stepper Motor to the controller board. The Stepper Motor board also has  + and  –  charge to power up the lights. Each lights switches go  A-D   has switched around several number steps where you are going. When I   feel the motor sensor it feels hot and moving. In the  coding, I   needed to create a  Stepper control  to move amount  step where  is  going

Leave a Reply

Your email address will not be published. Required fields are marked *