Project 5

In, Project 5, I have spent 1 and a half hour to make water lever sensor work to work with  LCD Display. Since I was playing around to see why or not is working or is working. I was able to fix it in the end my troubleshooting the wiring error. When I started to find the error is the power for the LCD then I was able to get on. Then I decided to make power for the water sensor in button. The display shows the amount of water level I get the cup. When I   put water in full inside of the cup I will get a full water sensor gains the number of value is not in the cup  Water sensor gain less. The wiring for the water sensor needed a male to female wire to attached to the breadboard or the controller board.    I have spent 1 and a half hour to make water lever sensor work to work with  LCD Display. Since I was playing around to see why or not is working or is working. I was able to fix it in the end my troubleshooting the wiring error. When I started to find the error is the power for the LCD then I was able to get on. Then I decided to make power for the water sensor in button. The display shows the amount of water level I get the cup. When I   put water in full inside of the cup I will get a full water sensor gains the number of value is not in the cup  Water sensor gain less. The wiring for the water sensor needed a male to female wire to attached to the breadboard or the controller board.

 

Leave a Reply

Your email address will not be published. Required fields are marked *